A&D SV-10A Manual de instrucciones descargar pdf (Pagina 84)

(2) How to remove and attach the surface locator plate (Only for SV-10A/SV-10H/SV-100A/SV-100H)

Removing

Loosen the screw and remove the surface

locator plate from the temperature sensor.

Attaching

Install the surface locator plate as

shown in the illustration. Slip the locator

plate onto the temperature sensor.

Move the plate to the top of the sensor.

Adjust the position of the locator

plate so that the tip of the locator

plate aligns to the center of the

narrow part of the sensor plates.

Tighten the screw.

Note

When the sensor plate and the surface locator plate are too close, a measurement

error may occur due to the liquid surface tension. Therefore, secure a clearance of

at least 1 mm between the sensor plate and the surface locator plate. Maintain the

clearance by rotating the surface locator plate when necessary.

(3) How to remove the sensor protective cover (For all models)

Remove the protector and the surface

locator plate.

Pull the sensor protective cover in the

direction indicated as 1 to release the

portions A (two) and B from the

protector frame.

Pull the sensor protective cover in the

direction indicated as 2 to remove.

Note

When removing the sensor protective

cover, it may touch the sensor plates

and the temperature sensor. Use

much care not to damage them.

Clearance

of 1mm o

reate

Surface

locator plate

(Shaded portion)

Only for

SV-10A/SV-10H

SV-100A/SV-100H

Sensor protective

cover

Sample

surface

adjustmen

osition

Sensor

lates

Temperature

sensor

Screw

Sensor protective

cove

Protector

frame

(Sensor unit underside view)

(Example: SV-1A/SV-1H)

(Sensor unit side view)

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 101 102

Comentarios a estos manuales

Sin comentarios

A&D SV-10A Manual de instrucciones Pagina 84

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control A&D SV-10A