page 2/7
www.cpksoft.com
www.facebook.com/
cpksoftengineering
cpksoftengineering@
hotmail.com
phone: 54-911-45788354
CPKSoft Engineering
Industrial communication
drivers
.
solutions for Windows
XAND4325 technical specifications
General information
XAND4325 allows you to connect to the A&D COMPANY Ltd., AD-4325V weighing indicator
scales.
CONFIGURATION:
In order to configure parameters related to the scale communication, the following steps must be
followed:
- 1) Press STND\OPR. The display must be turned on.
- 2) Open the front panel cover where the Dip-Switch are.
- 3) Turn the Dip-Switch S3 ON. "Func" should be displayed and a "01" should blink on the
setpoint display.
- 4) Using the keys "<", ">", "+" and "-" select the number of the function to be changed and hit
"ENTER". A 0 should blink on the final weight display.
- 5) Use keys "+" and "-" to enter the desired value. Then hit "ENTER" to set the value.
- 6) Once the configuration is ready, change the Dip-Switch S3 to OFF. "END" should be
displayed.
The following are the functions to configure:
F41 - WXYZ combined parameter, where
- W = Indicates Baud Rate (2-1200 Bauds, 3-2400 Bauds, 4-4800 Bauds or 5-9600 Bauds)
- X = Indicates data Bits and Stop Bits
- 0 = 7 Data bits and 1 Stop bit
- 1 = 7 Data bits and 2 Stop bit
- 2 = 8 Data bits and 1 Stop bit
- 3 = 8 Data bits and 2 Stop bit
- Y = Indicates Parity (0-Even, 1-Odd or 2-No Parity)
- Z = End of message (zero must be set,i.e. CR+LF)
F42 - Output Data
- 1 = Sends the same displayed information
- 2 = GROSS Data
- 3 = NET Data
- 4 = TARE Data
F43 - Output Mode Must be set on option 5 (Command Mode #2)
F44 - Output Availability Must be set on option 1 (Always available)
F45 - Output Format Must be set on option 1 (Sending with SP Code Number)
F46 - Communication Mode Must be set on option 2 (Sending with Address)
F47 - Address Number A number from 0 to 9 may be set.
Command list
Read Configured Value
Description of this command:
This command allows you to read the gross weight, net weight or tare according to the way the
scale is configured in the function 'F42'
Methods used to run this command:
Analog Input
Number of points accepted by this command:
1-4
Meaning of the DriverP0 parameter:
Indicates the station address (0-9).
Meaning of the DriverP1 parameter:
0
Values that are returned:
Value in PointValue (0) = Actual weight.
(7 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales