A&D TM-2564G Manual de instrucciones descargar pdf (Pagina 45)

6-7 Measuring the SpO

1. Turn on the POWER switch to start the SpO

measurement.

Note

• In SpO

measurement, the function of automatically compensating the LED to obtain suitable emission

for the patient works. Thus, it may take approximately 30 seconds to display the measured value.

• Do not apply the sensor on the same arm with the cuff attached. SpO

may not be measured correctly

during blood pressure measurement.

6-8 Measuring the Temperature (Optional)

1. Set the temp. probe to be used.

2. The instrument starts to receive the signal from the wireless temperature probe. Refer to the

instruction manuals of the temperature probe and the temperature receiver unit for details.

Note

• The communication status is displayed by the antenna mark.

6-9 Measuring the Heart Rate/Pulse Rate

The heart rate and pulse rate are measured in three ways, using the instrument.

The values are displayed according to the order of precedence of ECG, SpO

and blood pressure

The heart mark starts to flash and the sound is generated to synchronize the pulse detection.

Note

• The heart rate/pulse rate is displayed in different colors to indicate what measures the value.

Green = ECG , Blue = SpO

, Yellow = blood pressure

• The synchronized sound can be turned off by the volume setting.

• The heart rate/pulse rate measurement can be specified in the function setting. Refer to "6-14 Function

Setting".

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Sin comentarios

A&D TM-2564G Manual de instrucciones Pagina 45